Configuring default start-up settings the camera

This article describes how to configure the camera to use user-configured settings at power-up.       

A user set (GenICam) or memory channel (IIDC) is used to store the camera settings. The complete list of settings that are stored are found in your camera's Technical Reference manual. Settings stored can include frame rate, image processing, and binning information.

There is a factory-defined user set that is always available and cannot be overwritten. By default, the factory-defined user set loads at start-up. However, you can specify a user-defined set to be used at start-up.

For GenICam:

If the factory-defined settings are not ideal, they can be used as a starting point. From there, only a few features may need to be modified to achieve the desired configuration. The UserSetSave feature saves the current camera settings so that they can be recreated later. Once saved, these new custom settings can be loaded at any time.

The UserSetLoad feature loads the specified user set. 

For IIDC:

The last saved memory channel is used at start-up. To revert to factory settings, attempt to write to the default memory channel.